Thank you Travis (FlatOut)! Tensioner seems to work. I cannot run a shorter belt as that puts the tensioner arm up in to the edge of the AC compressor. I might look at pushing the tensioner out a bit further towards the radiator, but that starts to interfere with the fan and the pulley would be slightly off center with the belt. Going to see how this setup does, I just do not like the two sides of the belt being so close. Only did the idle and a couple of revs, but nothing flew off. Also note this is still with the 9.2" lower and 3.25 upper, going to see how that does with the tensioner, but I have an 8.2" lower and plenty of uppers on hand