Gen 1 66mm Single Build

Did a little hot side mock up. Going to have to get the cross over a little tighter to the oil pan.


 
Last edited:
I wish i'd known how and when you were doing this. I would have let you take my x over from my silverstate kit. It's run like your doing. Need any pics?
 
Pretty sure I've seen it Gregg,I did a lot of searching just don't rem the kit names,but sure, put one up.
 
Might not want to run it between the pan and tranny, down the road of you want a different pan then it won't fit.
 
Thanks Guys. I'm having fun with it for sure. Need to order some supplies tonight, hopefully have the hot side complete and ready to weld this coming week/weekend.
 
x2, a flex joint will take some of the stress from expansion off the pipes, my Pickrel kit has one on the x over.
In addition after a few heat cycles, if you ever remove it again you will have to fight like crazy to get it bolted back together.


 
You must log in or register to reply here.
Back
Top