Wanting to have the pimp ecu control my nitrous. I have a full expansion harness. I know pin 18 is nitrous in and recieves 12 volts. Pins 14 and 15 are nitrous out and go to ground. Attaching a rough sketch of what I think is correct wiring. I will be running a normally closed Hobbs switch on grounds for solenoids as I will be turning nitrous off at a certain psi. I could have just left everything wired in on wot microswitch like I had before but with 2 step now I can't.
Sent from my moto z3 using Tapatalk
Sent from my moto z3 using Tapatalk