Thisis the way to install the bar the easiest that I found.The one difference is that the bar that I choose was not cut [brace bar] which i9s for the ones getting shipped.
1]First thing to do is install the brace bar on the stub sticking
down.Their is a set of holes drilled and a supplied bolt to be
installed after you drill the hole THRU the stub bar.[done so you
can somewhat adjust to your height.
2]Now install the bar[make sure to have both of the seat belt
adjusters down [on pillar] and the seat belt bolt on the floor out
and the seat belt tucked away]
3]place the bar over the the stud sticking out on one side and install the nut[factory]LOOSELY!
4] do the other side the same way[may need some one to help
hold the bar up.
5]Once you have both ends on the studs slide the adjuster up till
the bar is even going across and is somewhat snug oupagainst
the studs.Remove one nut at a time,and install the supplies
washer taking care to make sure that it fitts OVER the sutd as
shown.
6] reinstall the nuts snugly.
7]Now install the brace bolt[were the lower attachment point is
for the seat belt] and tighten with factory bolt.
7]Once that is tight now tighten the nuts on the pillar.
8] Take a 3/8 drill bit and drill thru the stub shaft and install the
supplied bolt.ONCE you do that that is the final height of the bar
and it can not be changed without redrilling the hole.
9]Install your belts according to the manufacture.
STan
1]First thing to do is install the brace bar on the stub sticking
down.Their is a set of holes drilled and a supplied bolt to be
installed after you drill the hole THRU the stub bar.[done so you
can somewhat adjust to your height.
2]Now install the bar[make sure to have both of the seat belt
adjusters down [on pillar] and the seat belt bolt on the floor out
and the seat belt tucked away]
3]place the bar over the the stud sticking out on one side and install the nut[factory]LOOSELY!
4] do the other side the same way[may need some one to help
hold the bar up.
5]Once you have both ends on the studs slide the adjuster up till
the bar is even going across and is somewhat snug oupagainst
the studs.Remove one nut at a time,and install the supplies
washer taking care to make sure that it fitts OVER the sutd as
shown.
6] reinstall the nuts snugly.
7]Now install the brace bolt[were the lower attachment point is
for the seat belt] and tighten with factory bolt.
7]Once that is tight now tighten the nuts on the pillar.
8] Take a 3/8 drill bit and drill thru the stub shaft and install the
supplied bolt.ONCE you do that that is the final height of the bar
and it can not be changed without redrilling the hole.
9]Install your belts according to the manufacture.
STan