alarcont91
Active member
I looking to upgrade rear end with a tru trac and was wondering what all is needed to do the installation of this unit.
I did new bearings when I installed mine. I got lucky and was able to reuse the stock shims and have proper backlash/preload. Your results may vary.I would do new bearings
And will need shims
Sent from my SM-G988U using Tapatalk
Are these the axles you used
https://www.moserengineering.com/1987-96-bronco-2wd-and-4wd-spline-31.item
Sent from my SM-G988U using Tapatalk
Ok. Do you know if those in the link are correct for our trucks
Sent from my SM-G988U using Tapatalk
Are these the axles you used
https://www.moserengineering.com/1987-96-bronco-2wd-and-4wd-spline-31.item
Sent from my SM-G988U using Tapatalk