4805 build thread

Pulled the engine tonight it's time for an after market pan, long tubes, mass air, 80bls injectors, mallory fuel rails and fab up the hot side of the rear / remote mount turbo ImageUploadedByTapatalk1374711973.566280.jpg
And other mods.
 
ImageUploadedByTapatalk1375026992.310219.jpg
What goes there where I'm pointing
My book states it a nipple 373724 but where does it go ?
Can some help me out with a pic ?
I pulled all the other sensors off to clean it up again
The 94 regular parts truck don't have it
 
Right Rear, pipe nipple or temp sender for H20. Use this port for your EFan sensor or hiding the gauge sender from the water neck. :)
 
Today's progress ImageUploadedByTapatalk1375062785.805666.jpg
Got the lower cleaned up and reinstalled with the 80lbs injectors and Mallory rails and lines in, cleaned up the valve covers
Removed more emissions parts ImageUploadedByTapatalk1375063101.202201.jpg
And plugged the hole
 
ImageUploadedByTapatalk1375318201.918413.jpg
ImageUploadedByTapatalk1375318275.263005.jpg
I can't get that fender well any cleaner I thought I was going to blast a hole in it with the pressure washer lol
 
Jason I can wait to see the truck in person that paint looks KILLER. It is the first time visiting this thread Where the H E L L have I been the last 5 months
 
Jason, are you going to drive that before you install the turbo? Looks like its almost ready to ROLL! :)
 
You must log in or register to reply here.
Back
Top