Solo Spec roll bar

[Sloe Truk]

Stan,

Could/Would you make a Solo 1 or 2 spec 4 pt. roll bar? If not what size tubing and wall thickness is required and what would your suggestions be as to making one?

Thanx
Sloe Truk

 

[Ruslow]

I use to make a 3 piont.the one down tube went to the pass side footwell from about the middle of the hoop.the problem with a 4 pt is that the down tubes to be leagal need to be from up high on the hoop so you either go thru the window or can not use the door.As for size it is based on wieght of vehicle so figure on that truck you might get away with a 1.75 .120 wall tube but more than likely a 2.00 tube.Stan

 

[Sloe Truk]

Thank you