Fuel WOT Function

[Jay Jr]

Okay. Trucks is up and running!
Read the tune and went and checked cold start, light/ part throttle cruise and so on. The start up tune very ballpark.
Yet, with the WOTx Function, file reads:

(x) 32/ 28.75/ 20.75/ 22.25/ 23.5/ 23.5/ 23/ 24.75/ 24.75
257.99/ 0/ 62.5/ 109.38/ 131.25/ 140.63/ 148.44/ 162.5/ 181.25

My question is, what are these low rpm values represent if they aren't actual or even ascending?
More over, the fuel multiplier values. Do these represent % x base fuel open loop fuel table?

 

[sailorbob]

I don't know what ecu you have and I'm not sure what s/w you are using but these are the stock 'WOT Fuel Multiplier' (aka FN303) and 'WOT Fuel Multiplier vs WOT Time' (aka FN310) functions from the C3P2 ecu.

I cannot see how those values you have translate to meaningful units. I suspect the s/w has something wrong (possibly the address) with regard to the function.

 

[sstock]

Those numbers are not correct, are you reading them on the wrong strategy??
I've seen that done before and none of the numbers will make sense.
Jay dont even try using the rt130 software, it has more holes in it than a screen door. Use the 120 version with the new LHBLO DAT file I sent you once upon a time.

 

[Jay Jr]

120 version with the new LHBLO DAT file are up and running great:clap: Had some good progress today