blower bracket recommendations

[shaunditty]

I will likely never reach that level.

I am shooting for some mid 12’s to keep up with most new junk and I’m good. I’m at 13.3 now and leaving some in the table.. that’s another thread though.

 

[FlatOut]

Man I wish I would have taken this pic from a straightView attachment 102864 on angle.

Ray, yours looks like it lines up significantly better than either of the ones I have. when compared to the PS and Alt pulleys and belt. I'll have to do a little bit more investigating

 

[bobwhite]

my Dave Pickrel bracket and spacers pretty-much lined up well (parallel to everything) when i installed it for mock-up. maybe you'll find the issue when you look at it again.

 

[scott sanderson]

Does anyone or would you consider making the 1'' intake spacer? I still have a phenolic one from 15 years ago, would consider an aluminum one without the EGR hole.

 

[rusty_408]

Throwing this out there for anyone to consider.

JD had this Novi 2000 bracket designed and made before I bought my truck. M&M machine shop made it (truecustoms.com). The top horseshoe piece had a little shake to it, but M&M worked with me to get it beefed up with 1/2 plate. Ben Miller is the guy's name. He just finished this revision. He has the program on file and can make it for anyone. It retains the air compressor and p/s pump in the same place and put the blower on it's own belt up top. Very impressed with the design and quality.

I might share on the FB group too.

Probably not out the question to revise the top horseshoe for a Procharger or other model either.