Atco Friday 7/25

TheHammer

TheHammer

NJLOC
nothing spectacular
just going with some friends to watch some test and tune and drink some beers hang out BS
if anyone else is interested come on down
 
Intake bolt holes are shot which is the main problem. They will not torque properly and they loosen up which is one reason why the lower gaskets keep failing. Second, lower intake angle may be off a touch. Seems the intake imprint is much deeper on the lower portion of the gasket. Going to also have a little work done to them to make sure they are 100%. No mre problems. I can't take it anymore.
 
Same crap you were telling me about at Cecil right Gregg?

Turned out to be a good time
Paul couldn't get any traction, Vinnie was testing out some new gears

Uncle Frank came, Lewis, Gary, Big Ant, Carl, Pauls Dad

good times
 
TheHammer said:
Same crap you were telling me about at Cecil right Gregg?

Turned out to be a good time
Paul couldn't get any traction, Vinnie was testing out some new gears

Uncle Frank came, Lewis, Gary, Big Ant, Carl, Pauls Dad

good times
Click to expand...

Yes. I kind of figured it just wasn't the gaskets. Tried some studs and I couldn't even get them to hold. They would start pulling up out of the intake. At least now it will be fixed. Glad you guys had a good time.
 
You must log in or register to reply here.
Back
Top