Latest activity

  • Blurry94
    Blurry94 replied to the thread Smog pump delete loose???.
    I had the exact same problem with one of those. Delete the smog pump and associated mechanical parts, if possible. Then you can run a...
  • JamesJ
    ya something got boogered up for sure, if that ground was bad would help explain some electrical issues im looking at too. I saw the...
  • core-rider
    core-rider replied to the thread #439 build thread.
    I’ll try unplugging it… II only ever see that behavior above about 90mph. Would be nice to get rid of it! Sent from my iPhone using...
  • sg990
    sg990 reacted to JBrady5979's post in the thread Found: Gen 1 Chassis with Like Like.
    Found one, thanks
  • S
    slow94 replied to the thread '93 Replacement Driveshaft.
    I would think it needed to be from another e4od truck no? Not sure if the 4r70w trucks have same length shaft and same spline count...
  • Required
    Required replied to the thread #439 build thread.
    Unplug the dumb RABS +1
  • core-rider
    core-rider replied to the thread #439 build thread.
    Yeah, just need to add it to the list along with wiring a button for 2-step/launch control. Sent from my iPhone using Tapatalk
  • FMOS Racing
    FMOS Racing replied to the thread #439 build thread.
    PxS is all the controller you need. Just order the solenoid and pigtail from Stinger. Wire it up and enable boost control. There's a...
  • glenbartley
    glenbartley reacted to 94whtlite#2669's post in the thread Wheels with Like Like.
    The drop beams are in. Already had springs. Going to keep the 255/35 on the front. Still need to lower the back. Will pulling a leaf and...
  • 93raven
    93raven replied to the thread '93 Replacement Driveshaft.
    Any driveshaft from a short bed truck with the automatic transmission and a v8 should be the same.
  • J
    jdgerz replied to the thread '93 Replacement Driveshaft.
    Yea truck had been sitting for a while outside and the yoke was partially out of the trans when it sat after driveshaft fell out lol.
  • J
    jdgerz replied to the thread '93 Replacement Driveshaft.
    Thanks good to know, so does any normal f-150 driveshaft with the same dimensions work, not just the specific lightning one?
  • Steve83
    So he rammed the wrong bolt in? Sounds like he owes you a good repair of the block. But did you look at that pic? There's another ground...
  • FlatOut
    FlatOut reacted to core-rider's post in the thread #439 build thread with Like Like.
    Local shop had a dyno day today… I was expecting 280-300hp… was very surprised to see 378hp 506tq at 9psi (which was probably 8psi...
  • FlatOut
    FlatOut reacted to 94whtlite#2669's post in the thread Wheels with Like Like.
    The drop beams are in. Already had springs. Going to keep the 255/35 on the front. Still need to lower the back. Will pulling a leaf and...
Back
Top