Psi?

[MorpheusGPR]

Is this PSI where Matt works? If so I hear you are the person to see about some engine parts for a Chevy

I have the heads off a chevy 350 (corvette motor) 1970 LT-1 block.

What specs will you need to get me correct parts for the heads?

I had some springs fall apart so I will need at min. springs, and I think valves. I would like to get good quality parts, titanium? I am considering getting the heads ported while they are off but only if the cost is low.

Let me know and I will try to get some more specs, it was built for my Dad years ago.

A couple of the rockers appeared to have some rubbing on the sides from after the springs fell apart. I am hoping they are ok though.

Thanks.

[Blue Oval Forever]

Phil, I think this is the Vendor your looking for.

http://www.nloc.net/vbforum/forumdisplay.php?f=593