FireFighter_54
New member
"Newer" member here having lots of trouble with one specific point of datalogging with my Tweecer R/T.
I have everything installed properly. Wideband is ran through the EGR wire with correct voltage inside and out and the gauge is reading. DIYWB selected in the payload on CalEdit. Correct strategy selected, ICY0. But, no A/F reading when I try to log. All other aspects are recording correctly and the A/F on the dashboard in CalCon shows up but doesn't change as if there is no reading. I've probably gotten on Mike's last nerve as I've been emailing him trying to figure out the problem. He sent me a REGS.dat fill that I saved then rebuild my payload and still no change. He said it seems I'm doing everything correct and I've been searching multiple forums with no luck in finding someone who's had the same problem as myself.
Wideband unit is a Glowshift w/ datalogging output
Any help is appreciated.
I have everything installed properly. Wideband is ran through the EGR wire with correct voltage inside and out and the gauge is reading. DIYWB selected in the payload on CalEdit. Correct strategy selected, ICY0. But, no A/F reading when I try to log. All other aspects are recording correctly and the A/F on the dashboard in CalCon shows up but doesn't change as if there is no reading. I've probably gotten on Mike's last nerve as I've been emailing him trying to figure out the problem. He sent me a REGS.dat fill that I saved then rebuild my payload and still no change. He said it seems I'm doing everything correct and I've been searching multiple forums with no luck in finding someone who's had the same problem as myself.
Wideband unit is a Glowshift w/ datalogging output
Any help is appreciated.