Moates Quarterhorse Install_ Data cable routing

[davsta]

Seeking guidance from those who have installed a Moates QH previously. Specifically the routing method of the data cable into the cab area from the ECM

Removal of the E Brake assembly allows for a clear view of the ECM although that area appears to be isolated with the E Brake assembly in place.

Appreciate your time and guidance sharing lessons learned.

Regards
David

 

[rusty_408]

i just did this again this week. That the ECU out. Take a stiff wire and from the engine compartement side fish it upwards and towards the passenger side, it should poke through from just behind the ebrake braket. The use it to pull the data cable through.

Bascially the ECU holder is open at the top. Just need to get the wire routed.

 

[davsta]

Thank you Sir. Very much appreciated.

 

[FMOS Racing]

There's room above the ebrake to route wiring. I have a LOT of wires running through there. Just pull the ebrake out. Note that there is a "offset" at the top of the brake bracket where the switch is attached. There's plenty of room through there.