huffentuff95
Active member
Yes Steve ,I've tried everything.. I feel like a little mouse Well BIG Mouse in that maze where it hit a wall and can't figure out what to do next. I thought I did save a WOT number maybe it was a fluke but every time I try to change a Base open loop fuel table, No matter what I do open, save as, enter rename,single click, open and do again ...:? When I close out and go back into the file the new info is not there.... It changes the Numbers when you click (set ) but I can't save it.. I will bring it to Chip and if he confirms it I'll know it's not me!!!. I changed files at the WFC10 and that worked. wondering if I should load the disc again to be sure. No dyno for me till I get the file changes down pat cause if not it's a waste of time