idler pulley question...

[LuvMyL]

do your dual 100mm idler pullies require a different size belt?

I have your 6lb lower pulley and belt that you all supplied. it went on REALLY tight with the stock idlers.

-thanks

 

[LuvMyL]

?

 

[Lightninforce]

?

Are you going to incorporate our billet snubber with the 100mm idlers? Or just swap out the stock steel 90mm idlers for our billet 100mm's? Is your blower pulley still 2.93? All of the above factor into different belt lengths.

Mark/LFP
1-281-385-5339
www.lightningforceperformance.com
" Check IT Out "

 

[LuvMyL]

no billet snubber....just a swap out. Upper pulley is stock size. I just have your 6lb lower with the belt that was sent with that kit.

 

[Lightninforce]

Our LFP 100mm billet idlers will not work. With stock 2.93 upper the 100's will touch. You will need 90mm's and your existing belt will be fine.

Mark/LFP
1-281-385-5339
www.lightningforceperformance.com
" Check IT Out "

 

[BLWN2K2]

what if you use 1-100mm and 1-90mm? would that work or be better than 2-90mm??:hijacked:

 

[BLWN2K2]

1-90mm and 1-100mm or 2-90mm for use with the aux idler kit you sell on a stock upper.

 

[derekrpd]

I would also like to know with the stock upper and 6# lower will 1 100 and 1 90mm work and what belt length? 69"? Thanks.

 

[Lightninforce]

With a stock upper and our 6# lower you would use a 685 belt. If you are looking to help with any sort of belt slip you need our snubber/idler bracket with the LFP replacement idler pullies. Pullies alone will not accomplish this. With the 2.93 upper the larger 100mm idlers will not work.

Mark/LFP
1-281-385-5339
www.lightningforceperformance.com
" Check IT Out "