header clearance?? clutch slave cylinder

[jetblackbronco]

i am planning on ordering a set of the 1 5/8 HTS headers, and then had an revalation....at: i was lookin at pics of them installed on another truck, and noticed they are exreamly close to the bellhousing.
i was wondering if they would clear a clutch slave cylinder mounted on the driver side??????????? i ask this because i plan on dropping the E4OD, and replacing it with a 5 speed manual.....in the near future

 

[Icepick]

There is a lot room on the drivers side as is and with the much smaller manual tranny I'm about 90% sure it clear the clutch cable without any problems...