RAIDEN
Moderator
I finally bought my gauges and A-pillar pod. I got the cobalt - boost, fuel pressure, and water temp. gauges. Took me about four hours to make a clean install.
1st step was to color match the pod to the interior.
Next was installing the sending units.
Fuel pressure sending unit.
Water temp. sending unit. I decided to drill and tap the thermostat housing so that I can see if the thermostat is working properly.
Then finally the wiring and the gauges.
Gauges w/ the lights on.
1st step was to color match the pod to the interior.
Next was installing the sending units.
Water temp. sending unit. I decided to drill and tap the thermostat housing so that I can see if the thermostat is working properly.
Then finally the wiring and the gauges.
Gauges w/ the lights on.