upgraded internals package

12-17-2001, 05:13 AM

i just read the "hey jerry" post and was wondering, it would be cool if you guys put together some kind of internals package. with new rods, pistons, and everything else required to install them. do you or are you going to have some type of package like this? IMO, something like this would sell.
anyway, just a thought

joe

12-17-2001, 11:29 PM

J15BIG,

We are putting something together working with a couple of manufactors.
I will post later on this.

Jim@JDM

12-18-2001, 09:25 PM

stop dammit. stop coming out with more goodies. i'm only 18 and with what little mods i have and the little bit of money i make i will never catch up. so stop lol

------------------

12-18-2001, 09:56 PM

Bring on that beefy bottom end Jim, the 400 plus H.P. that we are making could probably use a little insurance. It's nice keeping it all together. Go for it, Jim!!! John H.

12-19-2001, 04:05 PM

Steel Crank is Good
Add Some Manley Rods
Good Bolts
JE pistons and you're set except for making sure the block is prepared and your clearances check out.

Oh yeah - probably should balance the rotating assembly.

[This message has been edited by Need4Speed (edited 12-19-2001).]

12-17-2001, 05:13 AM	#1 (permalink)
J15BIG Guest Posts: n/a View this user's gallery iTrader: / %	upgraded internals package i just read the "hey jerry" post and was wondering, it would be cool if you guys put together some kind of internals package. with new rods, pistons, and everything else required to install them. do you or are you going to have some type of package like this? IMO, something like this would sell. anyway, just a thought joe

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode




Home \| Classified Ads \| Gallery \| Join the Club \| Register on the Forum \| Merchandise \| Supporting Vendors \| Chat

12-17-2001, 11:29 PM	#2 (permalink)
Jim@JDM Guest Posts: n/a View this user's gallery iTrader: / %	J15BIG, We are putting something together working with a couple of manufactors. I will post later on this. Jim@JDM

12-18-2001, 09:25 PM	#3 (permalink)
spanky777will Guest Posts: n/a View this user's gallery iTrader: / %	stop dammit. stop coming out with more goodies. i'm only 18 and with what little mods i have and the little bit of money i make i will never catch up. so stop lol ------------------

12-18-2001, 09:56 PM	#4 (permalink)
Johnny AC Guest Posts: n/a View this user's gallery iTrader: / %	Bring on that beefy bottom end Jim, the 400 plus H.P. that we are making could probably use a little insurance. It's nice keeping it all together. Go for it, Jim!!! John H.

12-19-2001, 04:05 PM	#5 (permalink)
Need4Speed Guest Posts: n/a View this user's gallery iTrader: / %	Steel Crank is Good Add Some Manley Rods Good Bolts JE pistons and you're set except for making sure the block is prepared and your clearances check out. Oh yeah - probably should balance the rotating assembly. [This message has been edited by Need4Speed (edited 12-19-2001).]