Got a kenne bell, worried about the boost. . .

ELScorcho · 10-06-2007, 03:47 PM

So I just bought a used kenne bell (Thanks LuvMyL!!), and I'm going to install it soon, but I'm worried about my boost level. Right now I have a 6# lower and the KB came with a 3" and a 2.75" pulley. I'm doing all this on a stock block, so with that 3" upper and 6# lower be too much? If it is, where can i buy a bigger upper pulley??

svt4047 · 10-06-2007, 04:04 PM

You could always put the stock crank pulley back on don't forget.
Otherwise I've seen numerous KB pullies both here and over on SVTperformance board.

Roach

svt4047 · 10-06-2007, 04:06 PM

BTW...

10-06-2007, 03:47 PM	#1 (permalink)
ELScorcho Gloss rhymes with hair Join Date: Nov 2006 Location: San Jose, CA Posts: 356 View this user's gallery iTrader: 0 / 0%	Got a kenne bell, worried about the boost. . . So I just bought a used kenne bell (Thanks LuvMyL!!), and I'm going to install it soon, but I'm worried about my boost level. Right now I have a 6# lower and the KB came with a 3" and a 2.75" pulley. I'm doing all this on a stock block, so with that 3" upper and 6# lower be too much? If it is, where can i buy a bigger upper pulley??

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode




Home \| Classified Ads \| Gallery \| Join the Club \| Register on the Forum \| Merchandise \| Supporting Vendors \| Chat

10-06-2007, 04:04 PM	#2 (permalink)
svt4047 Registered User Join Date: Dec 2006 Location: COLUMBUS, OH Posts: 1,768 View this user's gallery iTrader: 6 / 100%	You could always put the stock crank pulley back on don't forget. Otherwise I've seen numerous KB pullies both here and over on SVTperformance board. Roach

10-06-2007, 04:06 PM	#3 (permalink)
svt4047 Registered User Join Date: Dec 2006 Location: COLUMBUS, OH Posts: 1,768 View this user's gallery iTrader: 6 / 100%	BTW...