| | ||
![]() | | |
| | ||
| Home | Classified Ads | Gallery | Join the Club | Register on the Forum | Merchandise | Supporting Vendors | Chat | ||
| | #1 (permalink) |
| Kamikaze Rusty Paid Member | Tweecer Parameter Questions I posted some of these on my local section, but figured this is the right spot for them for everyone to chime in or read. -The CID says 282 on the stock bin, is this correct? -The NVBASE, is this the Speedometer factor? -The presence of KIHP, can a knock senor be added to the truck? To my knowledge we don't have knock sensors. If so which pin would it be mapped to? -"WOT TPS Breakpoint Voltage" is set to 650 Volts??? There must be an error here right? -FN1303 "Accel enrichment" table, anyone shed some light on this table? The software notes are not very clear. -FN1320 "volumetric efficiency" table, anyone shed some light on this table? No software notes. -Which tables are being modified with regards to the transmission parameters to keep the tranny in 3rd when tuning? Just downshift tables?
__________________ **1994 Lightning** 95% Stock, >200k miles (KB build in the works) **1984 F-150 (R.I.P.)** KB Supercharged 5.8L, AFR 185s, 90mm Mass Air w/ 42lbers, AOD w/ MegaShifter, Autometers, Gen1 Lightning Rear & Wheels, Billet Wheel, Shaved Doors... etc. |
| | |
| Thread Tools | |
| Display Modes | |
|
|