huffentuff95

I was trying to richen a complete base open loop line on my laptop. I know how to high light the top line in blue and SET by multplying by 0.99 or less to richen the whole table. It changed the values but how do I save it ??? I tried to save it and when I open the file back up I still have the old values in the table. so I went to plug it in my tweecer to write the tweecer BUT when I shut the key off and try to read the file I just put in the Valve never changed. I know I am doing something wrong just a little help here. What I want to do is change a few files that I have already stored in my saved programs without being hooked up to the truck and have them in stand by to load in the event I get it on the dyno soon!!!

marc2000gt

Dennis, are you pressing enter after each change? If not it won't save the changes that you made.

__________________
1994 Red Lightning #1134 383ci by PSI, S-Trim, Trick Flow T/W heads, Trick Flow Box intake, 60lb injectors, Struckby Two Pump Trick, MSD 6AL, Flexalite 295's, Pickrel Magnaflow Exhaust, Art Carr 2800 stall converter, FTVB, LFP Traction Bars, Struckby mass air wiring, PMAS HPX Mass air sensor. Tweecer RT, Wideband Commander, Binary Editor, EEC Analyzer.

huffentuff95

After I hi lighted the line than entered the X by and the line numbers changed ,I then hit enter but when I clicked on the blue box (Save to disc ) I go out of that file and go back in and the old nubbers are still there not the new #'s

Super Glide

Ah Gawd a repeat student!
Once you make your changes click on the save button, then it will open a small box for you to name the new file and permit you to save it in a specified location. Then reopen file and verify the changes prior to writing the file to the tweecer.

huffentuff95

Alright I don't have the program with me
(where is the save button on the screen) , I couldn't seem to locate one lastnight. Yes it wouldn't let me rename it or save as !!!!! So Sorry masterson!!!