Timing??

01-06-2002, 11:58 AM

Hello,
I cannot seem to find the spout connector that I need to remove to correctly adjust my timing. Any help would be great. And also I purchased a superchip, do I need to set my timing back to 10 degrees or not? Thanks Jeff

01-06-2002, 12:09 PM

Look on or near the driver's fender for a two wire loom and a gray plastic connector, this is the spout. Go ahead and separate then shoot your timing, then don't forget to reconnect. I would experiment with initial timing with your chip. Fuel octane that you run will determine how much timing you can get away with.
Later
Steve

01-06-2002, 12:10 PM

Jeff, the spout connector is under the hood on the drivers side in front of the processor. It is a black wire with a gray plug. When you unplug it the tone of the engine will change. Also I had a superchip and I had to set the timing back to 10deg. Good luck.

01-06-2002, 12:18 PM

Thanks for the help.
Jeff

01-06-2002, 11:58 AM	#1 (permalink)
svtlightning Guest Posts: n/a View this user's gallery iTrader: / %	Timing?? Hello, I cannot seem to find the spout connector that I need to remove to correctly adjust my timing. Any help would be great. And also I purchased a superchip, do I need to set my timing back to 10 degrees or not? Thanks Jeff

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode




Home \| Classified Ads \| Gallery \| Join the Club \| Register on the Forum \| Merchandise \| Supporting Vendors \| Chat

01-06-2002, 12:09 PM	#2 (permalink)
sstock Guest Posts: n/a View this user's gallery iTrader: / %	Look on or near the driver's fender for a two wire loom and a gray plastic connector, this is the spout. Go ahead and separate then shoot your timing, then don't forget to reconnect. I would experiment with initial timing with your chip. Fuel octane that you run will determine how much timing you can get away with. Later Steve

01-06-2002, 12:10 PM	#3 (permalink)
94BOLT Guest Posts: n/a View this user's gallery iTrader: / %	Jeff, the spout connector is under the hood on the drivers side in front of the processor. It is a black wire with a gray plug. When you unplug it the tone of the engine will change. Also I had a superchip and I had to set the timing back to 10deg. Good luck.

01-06-2002, 12:18 PM	#4 (permalink)
svtlightning Guest Posts: n/a View this user's gallery iTrader: / %	Thanks for the help. Jeff