Just installed my springs

04-18-2001, 09:05 PM

Whats up everyone. I just installed my eibach springs. Before I installed them my truck sat 31" in front now it sits at 30" not bad for the money. And what a pain in the *** to install took me about 2 hours. This is only the second mod I have done to my truck that actually involved wrenching. Cant wait until the header and the x-pipe install.

------------------
93L#5173
underdrives
14 degree timing
3chamber flows

04-19-2001, 02:09 AM

I know the feeling, just make sure that your tighten the bolt in the "cup" that the spring bottom sits in. You should have had to put the wrench through the coils of the spring to tighten it. If it is not really tight, it will start "clunking" when you get on some bumps

------------------
94 lightning
NOS GT-40 kit @150hp
Gears
Pulleys
X pipe
Shift kit
14.5 @93 mph N/A
13.4 @100 mph w/NOS hit speed limiter at the top end

04-18-2001, 09:05 PM	#1 (permalink)
Dennis Saprinsky Guest Posts: n/a View this user's gallery iTrader: / %	Just installed my springs Whats up everyone. I just installed my eibach springs. Before I installed them my truck sat 31" in front now it sits at 30" not bad for the money. And what a pain in the *** to install took me about 2 hours. This is only the second mod I have done to my truck that actually involved wrenching. Cant wait until the header and the x-pipe install. ------------------ 93L#5173 underdrives 14 degree timing 3chamber flows

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode




Home \| Classified Ads \| Gallery \| Join the Club \| Register on the Forum \| Merchandise \| Supporting Vendors \| Chat

04-19-2001, 02:09 AM	#2 (permalink)
DAVE94LIGHTNING Guest Posts: n/a View this user's gallery iTrader: / %	I know the feeling, just make sure that your tighten the bolt in the "cup" that the spring bottom sits in. You should have had to put the wrench through the coils of the spring to tighten it. If it is not really tight, it will start "clunking" when you get on some bumps ------------------ 94 lightning NOS GT-40 kit @150hp Gears Pulleys X pipe Shift kit 14.5 @93 mph N/A 13.4 @100 mph w/NOS hit speed limiter at the top end