vortech pulleys gen 1

Fst Eddie · 12-05-2006, 11:22 PM

Will a Vortech 8rib off of a fox body mustang work on my Gen1 lightning with a Vortech S Trim

marc2000gt · 12-06-2006, 05:34 AM

Yes, they are the same pulley's.

Fst Eddie · 12-06-2006, 10:09 PM

Thanks, what about the grooved tentioner,it the fox body smooth

marc2000gt · 12-07-2006, 05:11 AM

It should all work fine. I have a Vortech Renegade setup on mine.

Fst Eddie · 12-07-2006, 07:50 PM

Thanks for the information. I'm going with Trick Flow track heat heads with a roller conv. what length push rods will I need. I know on mustangs you need a long push rod.

12-05-2006, 11:22 PM	#1 (permalink)
Fst Eddie vortech93lightning Join Date: Dec 2006 Location: Hickman,Tn. Posts: 7 View this user's gallery iTrader: 0 / 0%	vortech pulleys gen 1 Will a Vortech 8rib off of a fox body mustang work on my Gen1 lightning with a Vortech S Trim

12-06-2006, 05:34 AM	#2 (permalink)
marc2000gt Registered User Join Date: Nov 2002 Location: Appling,GA Posts: 3,818 View this user's gallery iTrader: 9 / 100%	Yes, they are the same pulley's. __________________ 1994 Red Lightning #1134 383ci by PSI, S-Trim, Trick Flow T/W heads, Trick Flow Box intake, 60lb injectors, Struckby Two Pump Trick, MSD 6AL, Flexalite 295's, Pickrel Magnaflow Exhaust, Art Carr 2800 stall converter, FTVB, LFP Traction Bars, Tuned with a Tweecer and a Wideband Commander Waiting to be installed is a Struckby Mass Air Setup with PMAS HPX sensor. 2000 Mustang GT

12-07-2006, 07:50 PM	#5 (permalink)
Fst Eddie vortech93lightning Join Date: Dec 2006 Location: Hickman,Tn. Posts: 7 View this user's gallery iTrader: 0 / 0%	Thanks for the information. I'm going with Trick Flow track heat heads with a roller conv. what length push rods will I need. I know on mustangs you need a long push rod. Last edited by Fst Eddie; 12-07-2006 at 07:55 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode




Home \| Classified Ads \| Gallery \| Join the Club \| Register on the Forum \| Merchandise \| Supporting Vendors \| Chat

12-06-2006, 10:09 PM	#3 (permalink)
Fst Eddie vortech93lightning Join Date: Dec 2006 Location: Hickman,Tn. Posts: 7 View this user's gallery iTrader: 0 / 0%	Thanks, what about the grooved tentioner,it the fox body smooth

12-07-2006, 05:11 AM	#4 (permalink)
marc2000gt Registered User Join Date: Nov 2002 Location: Appling,GA Posts: 3,818 View this user's gallery iTrader: 9 / 100%	It should all work fine. I have a Vortech Renegade setup on mine.