Heads/dyno

05-01-2001, 11:09 PM

Hey Joe Cloutier, whats up with your head swap and the dyno run? I'm curious about how much gain you recorded.
Mark Hebard
NLOC#332

05-02-2001, 12:30 AM

Well not so good.
I picked up 13hp 335 and lost 20lbs of tq 375 on pump gas. On 100 octane I picked up 30hp 352 and 11lbs tq 406.

We think it's a cam issue as I have elevated boost levels and no hp increase.
We know the cam made 550+ hp in Jeff's truck and the heads on James truck did the same. Byron is checking with Mike Wesley.
We may have stuck the cam in alittle off?
Raymond is letting me use his datalogger to see if there's anything else going on.
I hope it's just the cam.
I'm off about 30hp.
I'll keep you posted.

------------------
-Joe C.
#5190 in '93
13.80 @ 99.00 (so far)
Now with old used roller cam
and used heads!
Needing 12's

05-01-2001, 11:09 PM	#1 (permalink)
Badblacktruck Guest Posts: n/a View this user's gallery iTrader: / %	Heads/dyno Hey Joe Cloutier, whats up with your head swap and the dyno run? I'm curious about how much gain you recorded. Mark Hebard NLOC#332

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode




Home \| Classified Ads \| Gallery \| Join the Club \| Register on the Forum \| Merchandise \| Supporting Vendors \| Chat

05-02-2001, 12:30 AM	#2 (permalink)
LETSRCE Guest Posts: n/a View this user's gallery iTrader: / %	Well not so good. I picked up 13hp 335 and lost 20lbs of tq 375 on pump gas. On 100 octane I picked up 30hp 352 and 11lbs tq 406. We think it's a cam issue as I have elevated boost levels and no hp increase. We know the cam made 550+ hp in Jeff's truck and the heads on James truck did the same. Byron is checking with Mike Wesley. We may have stuck the cam in alittle off? Raymond is letting me use his datalogger to see if there's anything else going on. I hope it's just the cam. I'm off about 30hp. I'll keep you posted. ------------------ -Joe C. #5190 in '93 13.80 @ 99.00 (so far) Now with old used roller cam and used heads! Needing 12's