First was rebuilding the Kenne-bell, then was lower intake gasket and header gaskets in the hunt for my nasty gremlin (was killed in june), now I get to do that all again and add a cam swap and head swap to it.
Whell I got home at 6pm and cleaned up the carport a bit and pulled the L in (AGAIN)
let it warm up so my hands would be nice and cozy warm
.
Well a small mess later the heads are off and I will try to do the cam swap with the engine in the truck, if I feel the resealing the front cover dosen't go well than I will pull the motor and re do it properly.
I will be puttng in the H.O. roller cam and probably a new chain while I am there, then the AFR 185's, with luck I hope to hear it run again within 2-3 weeks.
I got lots of cleaning to do and weather will probably slow me down abit.
Next task is to degree the cam, then install heads and measure for the pushrods I will need with my new roller rockers.
tomarrow I will pull the cam and see if the front cover comes without destroying the oil pan gasket ect.
heres my poor truck as of tonight.
